1564587 Camshaft Position Sensor for Hyster Forklifts

Product Description

The 1564587 camshaft position sensor is a high-quality replacement part for Hyster forklifts. This sensor detects the position of the camshaft and sends a signal to the engine control unit (ECU) to adjust the fuel injection and ignition timing. It is compatible with various models of Hyster forklifts and is easy to install. It is made of durable materials and meets or exceeds the original equipment specifications.

THIS PART CAN ALSO BE FOUND UNDER THE FOLLOWING PART NUMBERS: HY1564587 1564587 HYSTER 1564587 HYSTER1564587 1564587.

Product Specifications

The specifications of the 1564587 sensor are mentioned below.

Warranty Information

This sensor comes with a 1-year warranty.

Applications

Forklift

Frequently Asked Questions

Q: How can I replace the camshaft sensor for Hyster forklifts?

A: You can replace the camshaft sensor by following these steps:

• Disconnect the battery negative cable.

• Locate the sensor on the engine block or cylinder head.

• Disconnect the electrical connector from the sensor.

• Remove the mounting bolt and pull out the sensor.

• Install the new sensor and secure it with the bolt.

• Reconnect the electrical connector and the battery cable.

Q: What are the benefits of using a camshaft position sensor?

A: Some of the benefits of using a sensor are:

• Improved engine performance and efficiency.

• Reduced fuel consumption and emissions.

• Enhanced engine reliability and durability.

• Easier troubleshooting and diagnosis.

Q: What are the risks of using a faulty or incompatible camshaft position sensor?

A: Some of the risks of using a faulty or incompatible sensor for Hyster forklifts are:

• Loss of engine power and performance.

• Increased fuel consumption and emissions.

• Damage to the engine components or catalytic converter.

• Safety hazards or accidents.

Q: What are the symptoms of a faulty sensor?

A: Some of the symptoms of a faulty camshaft position sensor for Hyster forklifts are:

• Reduced engine power and performance.

• Difficulty in starting or stalling the engine.

• Rough idling or misfiring of the engine.

• Check engine light or fault codes.

Q: How can I test the camshaft position sensor?

A: You can test the position sensor using a multimeter or an oscilloscope to measure the sensor's voltage output. You can also use a scan tool to read the data from the sensor and compare it with the specifications.

Q: How often should I replace my camshaft position sensor?

A: There is no specific interval for replacing your camshaft sensor. You should replace it when it shows signs of failure or when it fails a diagnostic test.

Need More Parts? More Parts From Lift Parts Warehouse

If you need more products from this category, we have here a large collection of:

• Sensor - T Map For Hyster: 1584472

• Sensor - Knock For Hyster: 1593661

• Sensor, Oxygen For Hyster: 4006802

At Lift Parts Warehouse, we carry many high-quality replacement parts to keep your parts in top condition. Browse our Hyster Switches/Sensors Parts Catalog here. If you need help finding the right part for your forklift, our expert customer service team is here to assist you at 1.800.210.8170. Shop now and experience the Lift Parts Warehouse difference.