206MX-4301 Curtis E-Z-GO 36V 350A PDS Controller
Category: Curtis Model 1206
Product Description
This is a Curtis 36 Volt and 350 Amp PDS (Precision Drive System) Controller for E-Z-Go Golf Carts with Parts Number: 1206MX-4301 or Curtis 1206MX-4301.
Cross Reference Numbers:
- CL7007826
- HU4067952
- YP550067819
- YP5500678-19
- 7007826
- 4067952
- 550067819
- 5500678-19
Suggested Accessories Parts Numbers:
Application: The Curtis Master Drive 1206MX-4301 PDS Controller fits all E-Z-Go Electric Golf Carts, Model 2000 and up.
Product Specifications
Specifications of the 1206MX-4301 E-Z-Go Controller:
Part Category |
PDS Cart Motor Controller |
Brand |
Curtis |
Drive System |
New Curtis Master Drive |
Current |
350A |
Voltage |
36V |
Controller Type |
PDS (Precision Drive System) |
Throttle Type |
ITS Throttle |
Weight |
2 lbs. |
Dimension |
6.5" x 4.5" x 2.5" |
Condition |
Rebuilt |
Curtis 1206MX-4301 PDS Controller
The Curtis Master Drive 1206MX-4301 is a remanufactured PDS Shunt Controller for E-Z-Go Electric Golf Carts. The PDS or Precision Drive System is a traction motor control system introduced by E-Z-Go in 2000. The PDS has a DC Motor which works as a traction drive capable of regenerative braking and a controller. It is responsible for regulating the speed level and performance of your vehicle while maintaining E-Z-Go safety standards.
Pre-installation Tests
Before installing the Curtis Master Drive 1206MX-4301 Controller, you must conduct a set of tests defined in the instruction manual that comes with the controller. Upon installation, you may encounter problems that may be due to a faulty controller or a faulty cart. The following tests will help diagnose if the fault is a cart fault or controller fault.
CHECK MOTOR WINDINGS:
- Set your VOM to RESISTANCE (Ω).
- With your motor disconnected, measure A1 to A2. This must measure BETWEEN .3Ω and 1Ω.
- With your motor disconnected, measure F1 to F2. This must measure BETWEEN 1Ω and 2Ω.
- With your motor disconnected, measure A1 to F1. This must measure OPEN.
- With your motor disconnected, measure F1 to motor case. This must measure greater than 5MΩ.
CHECK MAIN SOLENOID:
- Disconnect all wires from the main solenoid.
- Set your VOM to RESISTANCE (Ω).
- Measure the solenoid coil. This must measure NO LESS than 100Ω.
- Connect VOM leads to the main solenoid lugs.
- Attach jumpers from the main battery positive and negative to the coil (small terminals).
- The meter must jump from infinity to LESS THAN .3Ω.
- Remove jumpers and reconnect solenoid wiring from the harness. (If suppression diode is present,
- The non-banded side must go the blue wire – pin J1-6 from the controller.)
CHECK COTHERM:
- Inspect the cotherm (insulating material) mounted to the heat sink for holes, debris, and tears.
- Repair or replace, if necessary.
CHECK THE CART WIRE HARNESS:
- Check the connectors on the wire harness for corrosion, loose, broken, burnt or missing pins.
- Repair or replace pins as necessary.
Warranty Information
The EZGO 1206MX-4301 Controller comes with a 6-months limited warranty, extendable up to 36 months.
Frequently Asked Questions
Is this Curtis 1206MX-4301 a new Controller?
No, the Curtis 1206MX-4301 Controller is a rebuilt item.
What is the current rating of the Curtis 1206MX-4301 Controller?
This Controller is rated at 350 Amps.
Do I need to pay a core charge for the EZGO 1206MX-4301 Controller?
Yes, all remanufactured and rebuilt items are subject to a core charge. A core charge is refundable. The refund amount will be determined by the status of the core returned.
Which carts can use this Curtis 1206MX-4301?
You can use the Curtis Master Drive 1206MX-4301 Controller controller with any E-Z-Go Electric carts of Model 2000 and above.
What kind of throttle does it use
The 1206MX-4301PDS uses ITS throttle.
More Parts For EZGO Golf Cart
Beside Curtis 1206MX-4301 Controller, if you need More Electrical Parts for EZGO Golf Carts, we have a huge collection of
Are you looking for something else? Please browse our Part Catalog here. Lift Parts Warehouse provides quality aftermarket parts at a very reasonable price. All parts come with a limited 1 Year Warranty. We also guarantee a 100% fit for our parts.